Equipment Brands

S&A CW-5200DG Water Chiller 1.62kW

S&A CW-5200DG water chiller front view

The S&A CW-5200DG water chiller is an active refrigeration cooling unit engineered to stabilize operating temperatures in precision equipment, particularly CO₂ laser cutting and engraving machines, CNC spindles, and laboratory instrumentation. With a rated cooling capacity of 1.62 kW (approximately 5,527 BTU/hr), this unit provides precise temperature control necessary to preserve laser tube longevity, prevent thermal distortion, and ensure consistent beam output during prolonged operation.

CW-5200DG Water Chiller Specifications

  • Cooling Capacity: 1.62 kW (50/60 Hz dependent)
  • Temperature Stability: ±0.3°C
  • Temperature Control Range: 5°C to 35°C
  • Refrigerant: R-134a / R-410a (model variation dependent)
  • Reservoir Capacity: 6 L (1.58 gal)
  • Pump Flow Rate: Up to 10–13 L/min with max lift around 10–12 m
  • Power Supply: 110V/115V AC, 60Hz single-phase configuration

CW-5200DG Water Chiller Operating Modes

Furthermore, the unit features a digital controller with two primary operating modes:

  1. Intelligent Temperature Mode: Automatically adjusts coolant temperature relative to ambient room conditions. Consequently, this minimizes condensation risks on laser optics and tube surfaces during seasonal humidity spikes.
  2. Constant Temperature Mode: Locks water temperature to a user-defined setpoint. Therefore, it is ideal for tightly controlled manufacturing environments where thermal stability takes precedence.

CW-5200DG Water Chiller Protection & Safety

To safeguard connected equipment from thermal runaway, the CW-5200DG water chiller integrates several autonomous safety mechanisms:

  • Flow Alarm & Signal Output: Monitors circulation rates and triggers a relay to safely shut down the laser source if flow drops below operational thresholds.
  • Over-Temperature & Low-Temperature Alarms: Alerts operators whenever coolant falls outside specified safety limits.
  • Compressor Protection: Incorporates time-delay protection and overcurrent cutoff to prevent short-cycling and motor burnout.

Applications & Maintenance Considerations

Additionally, the chiller is designed for:

  • Cooling single CO₂ glass laser tubes rated between 100W and 150W, or dual lower-wattage tubes.
  • CNC router spindles rated up to 8 kW.
  • Welders, packaging equipment, and benchtop UV-curing systems.

For reliable heat exchange, position the chiller with at least 30 cm clearance at air inlets and 50 cm at the exhaust fan. Furthermore, always use distilled or deionized water to prevent scale buildup within internal piping, and clean the dust filter panels regularly to maintain rated heat dissipation.

Leave a Reply

Your email address will not be published. Required fields are marked *